Community DXP4800 Guia de Instalação descarregar pdf (Página 13)

Copy - Copy channels

SYSTEM-SETUP MENU:Copy

SOURCE:In1

TARGET:In2

Copy Channels from the source to the target. When the Source and Targets are both Inputs or

Outputs, all audio parameters will be copied. When one of the Source or the Target is an input

while the other is an output, only the Level, Polarity, Delay and EQ are copied.

 SOURCE - Channel to be copied from.

 TARGET - Channel to be copied to.

General - General system parameters

SYSTEM-SETUP MENU:General

FREQ MODE :All Freq

DELAY UNIT:01

DEVICE# :1

 FREQ MODE - Selects the frequency control mode for EQ and crossover filters. Can be

36 steps/octave or All Frequencies (1 Hz resolution).

 DELAY UNIT - ms, ft or m.

 DEVICE# - Assigns the device ID from 1 to 16. This ID is useful when a network of more

than 1 unit is present.

PC Link - PC Link Enable

SYSTEM-SETUP MENU:PC Link

PCLINK:On

 PCLINK: - PC Link Enable. It enables (On) or disables (Off) RS232 communication with

the PC software. It is recommended to turn off the link when the unit is not connected to

the PC.

Sampling - Sampling Rate Selection

SYSTEM-SETUP MENU:Sampling

SAMPLING RATE:96kHz

Community DXP4800 Owner’s Manual Page 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20 21

Sem comentários

Community DXP4800 Guia de Instalação Página 13