
Community Professional Loudspeakers, 333 East Fifth Street, Chester, PA 19013-4511 USA
CAUTION: Installation of loudspeakers should only be performed by trained and qualied personnel.
It is strongly recommended that a licensed and certied professional structural engineer approve the mounting design.
R2-64MAX
HIGH OUTPUT FULL-RANGE 60° X 40°
WEATHER-RESISTANT LOUDSPEAKER
R2- 64MAX [28AUG13]
Note: Cabinets are hand-laminated and measurements vary slightly due to the thickness of the berglass.
Dimensions shown should not be used to fabricate hanging xtures. Mounting points are approximate.
DIMENSIONS
The loudspeaker system shall be a horn-loaded, three-way, full-range triaxial design with two 12" inherently weather-resistant neodymium
low frequency drivers on a bass horn, one 2" exit Ferrouid-cooled midrange compression driver with a nonmetallic diaphragm and one
1.4" exit HF driver with a titanium/mylar hybrid diaphragm mounted on respective berglass horns built within the bass horn. MF/HF
drivers shall be connected to an integral passive crossover with a crossover frequency of 3300 Hz, the electronic biamp LF/MF crossover
frequency shall be at 450 Hz. The biamp input connection shall be two 16-2 12' (3.6 m) SJOW cables with stripped ends, one for LF and
one for MF/HF. The loudspeaker enclosure shall be an integral double-wall weather-sealed light grey berglass bell with a three-layer
weather-resistant grille. The steel grille shall be powder-coated with a proprietary zinc-rich epoxy dual-layer powder-coating process
color-matched to the enclosure. A steel yoke powder-coated with the same proprietary process, and color-matched, shall be included
with the system. The system shall have an IEC529 IP rating of IP55W with a minimum 5-degree downward aiming angle. There shall be
ve 1/2"-13 threaded mounting points. The system shall have a frequency response of 85 Hz to 18 kHz (-3 dB), LF input capability of
98V RMS, LF sensitivity of 103 dB at 1W/1m (100 Hz - 500 Hz) with a nominal impedance of 8 ohms; MF/HF shall have an input capability
of 35V RMS, MF/HF sensitivity of 108 dB at 1W/1m (400 Hz - 18 kHz) with a nominal impedance of 8 ohms. The nominal dispersion shall
be 60°H x 40°V from 1.6 kHz to 10 kHz. The loudspeaker shall be 24.75 in. (629 mm) H x 24.75 in. (629 mm) W x 30.75 in. (781 mm) D
and weigh 92 lbs (42.2 kg).
ARCHITECTURAL SPECIFICATIONS
Front
Top
Sides
13.5"
(343 mm)
Ø .53" (Ø 13.5 mm) typ.
(5) 1/2"-13
Threaded Inserts
12.38"
(314 mm)
24.75" (629 mm)
17. 25"
(438 mm)
30.75"
(781 mm)
Center of
Gravity
Center of
Gravity
Rear
Yoke
15.43"
(392 mm)
24.75"
(629 mm)
12.38"
(314 mm)
Center of
Gravity
8"
(203 mm)
8"
(203 mm)
Comentários a estes Manuais